Plumbing issues will soon be a thing of the past with these quick fixes you can do at home! Intimidated or don’t have the time? No problem, simply request service with Freedom Home Warranty and a couple clicks will get you fixed.
Plumbing Problem 1: Water Trickling Into the Bowl, or “Phantom Flushes”
Periodically, you may hear your toilet begin to voluntarily refill, as though someone had flushed it. Indeed, no one has, but don’t worry, your toilet isn’t haunted. A toilet that cuts on and off by itself, or runs intermittently, has a problem that plumbers call a “phantom flush.” The issue is a slow leak from the toilet tank into the bowl. This problem is almost certainly caused by a bad flapper or flapper seal. The solution is simple: drain the tank and bowl, check and clean the flapper seat and replace the flapper if it’s worn or damaged. Get detailed instructions here.
Plumbing Problem 2: Water Trickling Into the Tank
Do you hear a steady hissing sound coming from your toilet? This is a result of water trickling into the tank via the supply line. First thing’s first, check the float, the ballcock or inlet-valve assembly and the refill tube. The hissing sound is typically caused by water coming through the inlet valve. First, check to see whether the float needs adjustment, or if it’s sticking. Next, check to make sure the refill tube isn’t inserted too far into the overflow tube. (It should extend only about 1/4″ below the rim of the overflow tube.) If neither of these adjustments solves the problem, you’ll probably need to replace the ballcock assembly. Photos and detailed instructions here.
Plumbing Problem 3: The Bowl Empties Slowly
A weak flush, or a bowl that empties really, really slowly, is usually the result of clogged holes underneath the rim of the bowl. This is the easiest fix of all: use a curved piece of wire to poke gently into each flush hole to clear out any junk and bacteria. Coat-hanger wire works fine, and a small mirror will help you see under the rim. You can also use wire to loosen debris that may be blocking the siphon jet in the bottom of the drain. Be careful not to scratch the bowl, and make sure to use gloves and thoroughly wash your hands afterward.
Plumbing Problem 4: The Dreaded Clog
Clogs are definitely the most common of toilet problems. The good news is several tools can help you clear a clogged drain. A force-cup plunger is more effective for clearing minor clogs. Insert the bulb into the drain, and pump forcefully, careful not to spill waste water all over yourself or the floor. Slowly release the handle, letting a little water in so you can see whether the drain is clear. Repeat if necessary.
For serious clogs, use a closet auger. Insert the end of the auger into the drain hole, and twist the handle as you push the rotor downward. Use caution not to scratch the bowl.
Plumbing Problem 5: Leaky Seals
A standard toilet has at least five seals; each seal has the potential for leaking. The straightforward solution is to identify the faulty seal and tighten or replace it. The seal between the tank and bowl is the largest and most problematic. A break here will cause a major leak, with water shooting out from underneath the tank at every flush. Although it sounds intimidating, replacing this seal involves draining and removing the tank. First, turn the tank upside down for better access. Then, remove the old seal and pop on a new one.
The smaller seals at the mounting bolts and the base of the ballcock may also fail and cause smaller leaks. Replace these in the same way. Occasionally tightening the bolts or mounting nut is usually enough to stop the leak.
The final seal is the wax seal mounted on a plastic flange underneath the toilet base. This is a big deal because if this seal fails, water leaking underneath the toilet base will eventually rot the floor. Caulking around the base of the toilet without repairing the leak will only trap the water, making matters worse. To repair a leak around the base of the toilet, you’ll need to remove the toilet and replace the wax seal. If the leak is caused by a broken flange, request service with ACHW and we’ll hook you up with a professional plumber if you don’t have your own in mind.